How to make the automatic high-speed bag making machine work better, more stable and faster? Need to pay attention to the following issues:
      1. Keep the unloading and dragging of materials stable
      When unwinding, the height of the pendulum roller should not be too high or too low. When dragging the material, the tension should be appropriate. If it is improper, it will cause the material to vibrate radially during operation, which will eventually lead to errors in the bag length and stretch the bag length. In this case, it is necessary to clean the K frame and adjust the air pressure before and after the discharge pressure roller.
      2. The temperature setting should be appropriate
      If the temperature is too high, the bags will be wrinkled, leading to inaccurate photoelectric tracking, and the length of the bags produced will vary. To avoid tracking failure, you can increase the photoelectric sensitivity first, and then decrease the sensitivity after the temperature stabilizes. The suitable temperature is also different for the different materials of the products.
      3. Keep the product in the middle of the pressure roller
      Adjust the balance of the left and right gaps of the pressure roller to keep the left and right sides of the pressure roller in balance to avoid instability of dragging the material.
      4. The materials should be kept on the same level
      The flatness of the bag is affected by whether the pressure of the ironing knife is balanced, whether the material is on the same level, and so on.
      In addition to the above problems, the machine must run smoothly and quickly, and it is also necessary to set the computer parameters, so as to ensure the high-speed and stable long-term operation of the fully automatic high-speed bag making machine.